Two Minute Tips
Motor Testing MCA vs Megohmmeter
Traditional Megohmmeter testing will only detect faults to the ground; however, not all motor electrical stator winding failures begin as ground faults. View this quick tip to see if you have the right testing methods…
Using Vibration to Find Mechanical Faults
Use this quick tip as a guide for faulty types and ways to leverage technology to screen for impeding problems...
- Alex Deselle
- Fluke Corporation
Alignment Check vs. Alignment
One question that arises regularly in training is about doing alignment checks. Is it okay to just check the alignment? This quick tip will address the reasons for alignment check...
- Stan Riddle
- Acoem USA
Testing Thermodynamic Disc
When testing steam traps, we first need to make sure our temperature and pressures are set before we use any type of ultrasound. A good disc trap should cycle 4-10 times per minute; a warn disc trap will cycle ...
- Drew Walts
- IRISS
Inductive Imbalance in a Wound Rotor Motor
Testing wound rotor motors can be tricky depending on what and where you are testing. In this quick tip, see what rotor motors are used for and how to perform a test...
- Noah Bethel
- PdMA Corporation
Forgotten Alignment Tools
What if a spanner falls on your laser equipment screen? How will you get a proper reading? In this quick tip, you will see why you should never forget the old reliable tools...
- Dennis Swanepoel
- WearCheck
Use the Right Hydraulic Oil for Smooth Performance
Consider this when evaluating hydraulic oil: it’s not just about the viscosity grade. In this short tip you will learn how to select the right oil …
- Scott Leipprandt
- Lubrication Engineers
Understanding the P-F Curve
The P-F Curve is a critical and often misunderstood representation of asset health. In this quick tip you will learn the warning signs and how to prevent failure...
- John Bernet
- Fluke
How to Measure Your Machine’s RPM
If your machinery is not operating at the correct RPM, it will cause significant loss of time and productivity. This quick tip will show you how to correctly measure your machine's RPM…
- Stan Riddle
- Acoem USA